Light curing devices
A special lamp is required in the nail salon and also at home to cure the gel modeling. If the gel is not fully cured, lifting and discoloration can occur quickly.
It is therefore important to use the right light curing device. During nail modeling, the applied UV gel is cured and dried with a curing lamp. This works through the radiation of the lamps at a specific wavelength.
What is the difference between a UV lamp and an LED lamp?
Light curing equipment with UV/LED curing is more expensive to purchase, but it lasts longer and saves follow-up costs for the purchase of new replacement tubes. It also saves a considerable amount of time as it cures UV gels in a much shorter time and is extremely reliable.
Our LED lamps at a glance:
Our UV lamps at a glance:
If you want to spend less time on modeling, it is best to use our LED high-speed gels. The polymerization times are particularly short here. In LED devices with 410 nanometers, the gel takes around 30 seconds to harden, while 60 to 120 seconds is the rule in UV devices. If time is of the essence, these gels without added acid are the perfect alternative to classic gels.
The LED high-speed gels are available as 1- and 3-phase gels and can therefore be used as priming, build-up and sealing gels. The LED high-speed gels are mainly used in studios. Opt for the LED series and save time and money.
A classic 4-tube UV device is a good place to start, but you will soon notice the difference. Test our devices at the next trade fair and experience the difference for yourself.
